In Capture Security Center a VPN Tunnel Status shows UP

regarding VPN status. old question 🙂. the best way to see your phase 1/2 exchange is : expert# tcpdump -nni any port 500 or esp and host Firepower Management Center Configuration Guide, Version 6 Apr 16, 2020 Verify the VPN Tunnel | Help | Cisco dCloud Use the following commands to verify the state of the VPN tunnel: • show crypto isakmp sa – should show a state of QM_IDLE. • show crypto ipsec client ezvpn – should show a state of IPSEC ACTIVE; If the VPN tunnel is not up, issue a ping to AD1 sourced from VLAN 10. In Capture Security Center a VPN Tunnel Status shows UP

Configure IKEv1 IPsec Site-to-Site Tunnels with the ASDM

May 20, 2018 show vpn - arubanetworks.com

Apr 13, 2018

View the Status of the Tunnels The status of the tunnel informs you about whether or not valid IKE phase-1 and phase-2 SAs have been established, and whether the tunnel interface is up and available for passing traffic. Because the tunnel interface is a logical interface, it cannot indicate a physical link status. Configure IKEv1 IPsec Site-to-Site Tunnels with the ASDM Apr 13, 2018 Setting VPN IPSec tunnel with Fortigate – SOC Level 1 May 20, 2018 show vpn - arubanetworks.com